Chapter 9: System Settings1452. Click the desired tab to configure date/time settings for the UserStation. Configure the date and time using the tab labeledDate and Time(on page 145). If the date and time synchronizes with an NTP server in the "Dateand Time" tab, you must set the time zone correctly. SeeTimeZone (on page 146).Note: For "manually customized" date and time, the time zonesetting does NOT affect the time displayed onscreen, but it doesaffect the internal UTC-based clock. Therefore, make sure the timezone setting is correct and do NOT change it unless required.Date and TimeFollow one of the following procedures to set the date and time.To manually customize the date and time:1. In the Date and Time tab, deselect the time synchronizationcheckbox.2. Click a date in the calendar, and adjust the Hour, Minute and Secondsettings.To synchronize with the NTP time server:1. Select the time synchronization checkbox.2. NTP servers detected in your network are listed in the dialog. If the desired NTP server is not listed, click Add and type its IPaddress/host name. If any NTP server is incorrect, select it and click Edit to modify it. If any NTP server is not needed, select it and click Delete.3. Click Advanced Options to configure these checkboxes:
