Chapter 9: System Settings151Setting/button FunctionSame image in allmonitorsIf two monitors are connected, determinewhether both monitors show the same image.This setting is disabled when only one monitoris connected.Detect monitors Click this button if any connected monitor is notdetected. Usually it is not necessary to use thisfunction when there is only one monitorconnected.Show monitors inpanelDetermine whether the monitor shortcut icon isadded to the Main Toolbar. SeeMain Screenand Main Toolbar (on page 7).3. If any settings are changed, click OK to close the dialog, Apply tokeep the dialog open, or Cancel to cancel. If clicking OK or Apply, a confirmation message appears. ClickRestore Previous Configuration to restore to the original settings,or click Keep This Configuration to apply the new settings.Network ConnectionsYou can connect the two LAN ports of the User Station to the same ordiverse subnets.If you have connected both LAN ports to the network(s) when turning onor restarting the User Station, the User Stationrandomly selects one ofthe network connections as the default one. However, if you change thenetwork settings of either or both connections, the "final" one that ischanged will automatically become the default connection.Note: You can identify the default connection in the ConnectionInformation dialog. See Network Icon(on page 161).By default, both IPv4 and IPv6 addressing are enabled for both LAN ports,and the following are the default network settings:• IPv4:Automatic (DHCP)• IPv6:AutomaticTo change network settings:1. Choose Main Menu > System Settings > Network. The NetworkConnections dialog appears, with two factory default connectionslisted for two LAN ports.
