Chapter 5: Using the KVM Client53To temporarily exit the single mouse mode and then return to thismode:1. Press Ctrl+Alt+M on your keyboard. A message appears, indicatingthat the single mouse mode is temporarily suspended.Now you can use the mouse to control the User Station.2. To return to the single mouse mode, click anywhere on the targetserver's image in the KVM Client.Dual Mouse ModesIn the dual mouse modes, two cursors appear onscreen. They are:• The mouse cursor of the User Station.• The mouse cursor of the target server connected to the KVM port youare accessing.Two mouse cursors align if properly configured.While in motion, the User Station's mouse pointer slightly leads thetarget server's mouse pointer.Absolute Mouse ModeIn this mode, absolute coordinates are used to keep the User Station'sand target server's cursors in synch, even when the target server'smouse is set to a different acceleration or speed.This mode is supported on target servers with USB ports and is thedefault mode for virtual media CIMs.Use of virtual media CIMs on target servers is required for this mousemode. SeeVirtual Media CIMs (on page 70).Most modern operating systems on the target servers shall support theAbsolute mouse mode.Note: Some Linux, UNIX, Solaris or very "unusual" operating systems aswell as some USB profiles may not support the Absolute mouse mode. Inthis case, use other mouse modes. For detailed information of each USBprofile, see the section titled "Available USB Profiles" in the KX III KVMswitch's user documentation, which is accessible from the KVM switchapplication or the Raritan website's Support page(http://www.raritan.com/support/).To enter the Absolute mouse mode:• Click > Absolute.
