APPENDIX B: SYSTEM DEFAULTS 97Appendix B: System DefaultsDominion SX system defaults, as shipped from Raritan, are defined in the table below.I TEM D EFAULTIP Address 192.168.0.192Subnet Mask 255.255.255.0Port Address 51000Port address for CC discovery 5000Factory default username adminFactory default password raritanG ENERAL S ETTINGSModem DisabledRADIUS DisabledLDAP DisabledNTP DisabledLocal Port Access EnabledSyslog DisabledTACACS+ DisabledEvent Notification DisabledDialback DisabledIP-ACL DisabledTelnet DisabledSSH EnabledSNMP DisabledLogging to NFS DisabledS ERIAL PORTSBaud Rate 9600Parity NoneFlow Control NoneTo initiate access using http, Ports 80, 443 and 51000 (can be configured) must be kept open in the firewallin order for the unit to be operational. When using https SSL(S) only, TCP port 443 needs to be open; port80 can be closed. For SSH access, TCP port 22 needs to be open; for Telnet access, port 23 needs to beopen.Please note that you may need to open additional ports when using syslog, FTP (used in firmware upgradesfrom the GUI), NFS logging, LDAP servers, etc. These ports may vary from installation to installation,depending on network topologies, VLANs, and firewall configurations. Please contact your networkadministrator for site-specific information and settings.