CHAPTER 4: CONSOLE FEATURES 67The procedure for performing a factory reset varies depending on the model. For SX16 and SX32 units,the procedure is as outlined below. (For SX4, SX8, and other models with a RESET switch, please see theparagraph that follows):1. Power OFF the Dominion SX unit.2. Attach the supplied Factory Reset Connector (serial DB9 female) to the serial DB9 male port on therear of the unit3. Power ON the unit.4. The unit will restore to factory default settings. This process will take approximately 40 seconds.5. After 40 seconds, reconnect to the unit with the factory default IP address 192.168.0.192.6. Unplug the Factory Reset Connector.Note: It is advisable to remove the unit from the main network while performing a factory reset. Shouldanother device on the network have the IP address of 192.168.0.192, these two devices will be in conflict.For SX4, SX8, and other models with a RESET switch on the rear panel, using a ball-point pen (please donot use a graphite pencil), while the unit is powered ON, push in and hold the switch for about 30 seconds(or until the blue LED on the front of the unit goes off), and then release the switch. Only gentle pressure isrequired. The SX unit will detect the RESET switch and reset the unit to factory default. It will take about5 seconds for the unit to reboot. On these units, a reset to factory defaults can be performed with the unitpowered ON.Figure 70 Factory Reset Connector Location
