66 DOMINION SX I NSTALLATION AND O PERATIONS MANUALFactory ResetYou may want to perform a factory reset, or hard reset, to the Dominion SX unit to revert the configurationto known defaults. This is useful if the IP address of the unit is no longer known. Using the followingprocedure, the network settings of the unit will be reset to the values shown in the table below, and all portswill be reset to 9600 baud, no parity checking, and no flow control.Internet Address (IP) 192.168.0.192Gateway Address 192.168.0.192Subnet Mask 255.255.255.0Port Address 51000Port address for CC Discovery 5000Username adminPassword raritanNote: Factory reset does not remove the user-installed certificate from the unit.There are two methods for performing factory reset; via CLI, or by using a factory reset adaptor or a resetswitch, Both methods are outlined below. When resetting using a factory adaptor or reset switch, it is notnecessary to remove the device from all networks (an Administrator should make this decision).To factory reset via CLI, use the following commands:dominion:Diagnostics> factory_resetFactory Reset Network Settings:Name: DominionSXDomain: raritan.comSystem Port: 51000Discover Port: 5000IP: 192.168.0.192Net Mask: 255.255.255.0Gateway: 192.168.0.192Performing a factory reset will erase ALL system settings.All system settings will be returned to factory defaults, including network settings (e.g. ip, gateway, etcetera).Do you wish to continue? (no/yes) (default: no) yesReboot the machine; the following text appears:Welcome to Raritan Dominion ServerUsername: adminPassword: raritanAuthenticating [admin].....Authenticated.User Type [Administrator]User Name [Administrator]System is in reset state.Please enter new administrator password.New Password:Re-Enter New Password:
