8 DOMINION SX I NSTALLATION AND O PERATIONS MANUAL4. Click on the [Configuration] button in the left navigation panel to view the Configuration screens, andthen click on the Time tab to configure the current date and time. Features such as certificategeneration depend on the correct Timestamp, used to check the validity period of the certificate. Inaddition, the Syslog and NFS logging features also use the system time for time-stamping log entries.Figure 7 Time and Date Configuration Screen5. Set the Current Date and Current Time using the drop-down arrows to select the Month, Day, Year,Hour, Min. and Sec. values.6. To use NTP (Network Time Protocol), click on the Enable Network Time Protocol check-box andtype a valid IP addresses for the Primary Time Server and, if required, Secondary Time Server.7. Click on the [Update] button.8. Click on the [Network] tab to view the Network Configuration screen.Figure 8 Network Configuration Screen9. A network administrator typically assigns the values for these parameters. Please enter the followingdata – note that all fields are required:− Raritan Unit Name: Descriptive name for this unit− IP Address: Network address for this unit− Subnet Mask: Subnet mask for the network where this unit will reside− IP Gateway: Default gateway for this unit− Port Address: Default application communication port – if accessing the unit through a firewall,the TCP port specified during installation must be open.− Terminal Type: Terminal emulation type; fixed VT100/ANSI10. Click on the [Update] button.
