ŝ7ŞCautionƈ Leaking, overheating, or burst battery could result in fire or injury.ҮUse battery with the correct specification for the camera.ҮDo not short circuit, heat or dispose of battery in fire.ҮDo not insert the battery with the reverse polarities.ƈ Remove the battery when not planning to use the camera for a long period of time.Battery may leak corrosive electrolyte and permanently damage the camera’s components.ƈ Do not fire the flash while it is in contact with hands or objects. Do not touch the flash afterusing it continuously. It may cause burns.ƈ Do not move the camera while it is switched on, if you are using the AC Charger.After use, always switch off the camera before unplugging the cable from the wall socket.Then make sure that any connector cords or cables to other devices are disconnected beforemoving the camera. Failure to do so may damage the cords or cables and cause a fire orelectric shock.ƈ Take care not to touch the lens and where the lens cover is to avoid taking an unclear imageand possibly causing camera malfunction.ƈ Avoid obstructing the lens or the flash when you capture an image.An FCC warningҮThis device has been tested in accordance with the limits of a class B digital deviceunder item 15 of the FCC rules. These limits are designed to provide protectionagainst harmful interference in commercial installation. This equipment generates,absorbs and can emit radio frequency energy. If it is not installed and used inaccordance with the instructions, it may cause harmful interference to radiocommunication. There is however, no guarantee that interference will not occur insome situations. Should any interference occur when this device is in operation,please try one or more of the following measures.ƈ Change the location and direction of any aerial.ƈ Increase distance between the camera and the affected device.ƈ Use a different socket away from the affected device.ƈ Please contact a Samsung agent or a radio/TV engineer.ҮThis device complies with part 15 of the FCC Rules.ҮChanges or modifications not expressly approved by the party responsible forcompliance could void the users authority to operate the equipment.