INCOMING CALL DISTRIBUTIONIncoming calls can be assigned to ring a distributed station hunt group.This allows all members of the groupto share the call load.INCOMING/OUTGOING SERVICEOutside lines are available for incoming or outgoing service. Programming allows any outside line to be usedfor incoming calls only, outgoing calls only or both way service.INDIVIDUAL LINE CONTROLEach station in the system can be individually programmed to allow or deny dialing out as well as allow ordeny answering for each outside line.IP KEYSETSThe OfficeServ 7200 system allows the use of Samsung proprietary keysets that use Internet Protocols (IP) forvoice and data transport. They may be local to the system or installed in a remote location via a LAN/WAN.The OfficeServ 7200 can support up to 120 IP stations. An “IP station” is considered to be any of the follow-ing:WIP 5000 Wireless Handset, ITP5021D, ITP5012L, or Softphone. For more information on how to setup theIP keysets please refer to the VOIP Special Applications Section of the Technical Manual.ISDN SERVICEPrimary Rate Interface (PRI)The OfficeServ 7200 supports Primary Rate Interface ISDN. PRI allows simultaneous data calls, calling partyand calling line identification, high speed call setup and disconnect are among the benefits of ISDN calling.The 23+D configuration of ISDN allows call information to be delivered via the data channel (the “D” of23B+D) thus leaving the bearer channels (the “B” of 23B+D) available for single use or combined use to pro-vide a wider bandwidth for data and video. The OfficeServ 7200 supports the most popular protocol stan-dards in the U.S.PRI Protocols supported: National ISDN-2 (NI2)AT&T No. 5 ESSDMS 100/250LAN INTERFACEThe OfficeServ 7200 MCP card provides a 10/100 base T Ethernet interface for connection to a data network.This interface allows a high speed connection for PC programming across an IP network. This interface alsoallows the system software to be uploaded to the SmartMedia card via the OfficeServ™ Manager program.LEAST COST ROUTINGLeast Cost Routing (LCR) is the ability to automatically select the most cost effective central office route forthe outside number dialed by any station. The OfficeServ 7200 LCR program includes the following features:• Option to use or not user LCR or a tenant basis• Programmable LCR access code• Digit analysis table of 2000 entries each with ten digits• Routing by time of day and day of week (4 time bands per day)• Modify digits table of 200 entries• Flexible trunk group advance timer• Option to use or not use trunk group advance warning tones4.18