Samsung SF-4300 User Manual

Contents

Symptom‘The selected port is currentlybeing used. Restart yourcomputer and try again’message appears on thescreen.‘The scanner driver is notinstalled or an operatingenvironment is not set upproperly. Re-install thescanner driver and try again’message appears on thescreen.‘Port is disabled. Check if theport is properly connected,power is on, scanner is notbusy. Then restart yourcomputer’ message appearson the screen.‘Port is disabled. Check if theport is properly connected, orpower is on. Then restartyour computer’ messageappears on the screen.Cause and SolutionScan error occurred and the scanning has not been completedproperly. Reset your computer.Re-install the scanner driver. See page 1.21. If you still havethe same the problem, file setting required for I/O may not beproper. Follow the instructions below :1. Start your Windows.2. In Windows 95, select Run from Start menu.Windows 3.x users should select Run from File menuunder Program Manager.3. Type ‘sysedit’, then click OK.4. Select SYSTEM.INI file, and set the file as shown below.[386 Enh]device=vecp.386LPT1TurnAroundDelay = 505. Restart your Windows.I/O error occurs during scanning. Check for bad cable and thecable connection. If you still have the same message, open theSystem.ini file in the Windows directory as described above,and increase time as much as required in increments of 10.The printer cable may be improperly connected or the poweramy be off. Turn the power on. If you still have the sameproblem: turn the computer and printer off, and back on afterabout 10 seconds, then try again.3.11Troubleshooting3 Troubleshooting.. ....07-Troubleshooting 2/5/99 9:42 AM Page 11