Samsung VP-D353 Service Manual

Also see for SC-D351: Owner's manual Owner's instruction manual Owner's instruction book Owner's instruction book Owner's instruction book

Contents

Alignment and Adjustments3-11Samsung Electronics3-3-4(b) Back Tension Confirmation1) Set up the cassette-torque tape.2) Set to CAMERA mode, push the EDIT(+) KEY and check that the torque value of Reel S is 4±1g.cm.3) If necessary, proceed to step 4.4) If the Tension value is Low specified, moved to toward “a”.If the Tension value is High specified, moved to toward “b”.Reference : After changed, insert Cassette torque tape and confirm torque value.Fig. 3-14REEL DISK S TABLERESTING SURFACEREEL DISK T TABLERESTING SURFACECHASSIS MAINFig. 3-13ba3-3-4(c) PB/REV Torque check1) Set up the cassette torque tape.2) Set to CAMERA mode, Push the EDIT(+) button and check that the torque value of Reel T is 9.5±3.5g.cm.3) Push the EDIT(-) button and check that the torque value of Reel S is 15±4g.cm.4) If necessary, replace the defective Reel Disk S, T Ass’y.3-3-4(d) Reel Table Height Check1) RemovalŒ For the removal of the Housing Ass’y refer to 4-2-2 (page 4-7).´ For the removal of the Idler Ass’y refer to 4-2-3 (page 4-8).2) CheckŒ Using vernier calipers, check the following distances : From the upper surface of the Main Chassis to theresting surfaces of Reel S, T table should each be 3.9±0.15mm.3) MountingŒ For the removal of the Idler Ass’y refer to 4-2-3 (page 4-8).´ For the removal of the Housing Ass’y refer to 4-2-2 (page 4-7).