Sanyo PLC-SW30 Owner's Manual

Also see for plc sw30 - SVGA LCD Projector: Specifications Service manual Service manual Service manual Owner's manual

40Lamp ReplaceWhen the life of the projection lamp draws to an end, LAMPREPLACE indicator lights yellow. If this indicator lights yellow,replace the projection lamp with a new one promptly.ORDER REPLACEMENT LAMPReplacement Lamp can be ordered through your dealer. When ordering a projection lamp, give the followinginformation to the dealer.• Model No. of your projector : PLC-SW30• Replacement Lamp Type No. : POA-LMP57(Service Parts No. 610 308 3117)For continued safety, replace with a lamp assembly ofthe same type.Do not drop a lamp assembly or touch a glass bulb! Theglass can shatter and may cause injury.Allow a projector to cool, for at least 45 minutes beforeyou open Lamp Cover. The inside of a projector canbecome very hot.POWER LAMPREPLACEWARNINGINPUTOP CONTROLCAUTIONTurn off the projector and disconnect AC plug. Allow theprojector to cool at least for 45 minutes.Remove the two screws with a screwdriver and pull out thelamp assembly by grasping the handle.13Replace the lamp assembly with a new one and tighten the twoscrews back into the position. Make sure that the lampassembly is set properly. Replace the lamp cover and tightenthe screw.4To remove the lamp cover, remove the screw with a screwdriver .2Connect the AC Power Cord to the projector and turn on theprojector.6Follow these steps to replace the lamp assembly.Reset the Lamp Replace Counter.Refer to “Lamp Replace Counter” on the next page .5Lamp AssemblyHandleLamp CoverNote :Do not reset the Lamp Replace Counter when the projection lamp has notbeen replaced.ScrewsScrewThis indicator lights yellow when thelife of the projection lamp draws to anend.Lamp ReplacementMaintenance