Sanyo PLC-WL2500A Manual

Also see for PLC-WL2500A: Owner's manual Manual Quick reference guide Owner's manual Specifications

Contents

Sanyo PLC-WL2500A Manual Manual pdf 37 page image

PLC-WL2500A / WL2501A/ WL2503A Expand Serial Command Functional Specifications36/728.10.7 CF_DISP CommandCommand “CF_DISP_%1”[CR]%1“ON” ----------------------------- Select Display“OFF” --------------------------- Cancel Display“CNTDWNOFF” -------------- Count down OFF“UP” --------------- Switch Display mode forward(On → Countdown OFF → Off → On →…)“DN” --------------- Switch Display mode backward(On → Off → Countdown OFF → On →…)DetailsSet / Cancel DisplayThe value set by this command is stored in EEPROM and its setting is effectiveeven after ALL is OFF.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.8 CF_LOGO CommandCommand “CF_LOGO_%1_%2”[CR]%1 “0000”-”9999” ----------------- Set LOGO PIN CODE directly%2“OFF” ---------------------------- Disable Logo function“DFLT” --------------------------- Display Default Logo“USER” -------------------------- Display Captured Logo“UP” --------------- Switch Logo setting forward(OFF → DFLT → User → OFF → )“DN” --------------- Switch Logo setting backward(OFF → User → DFLT → OFF → )DetailsSet / Cancel LogoThe value set by this command is stored in EEPROM and its setting is effectiveeven after ALL is OFFThis command is available in normal Power ON status.%1--- Set LOGO PIN CODE- When LOGO LOCK is in operationPIN CODE is correct ------------------ Command is valid (Acceptable)PIN CODE is incorrect ---------------- Command is invalid (Error Code “102”)PIN CODE is out of %1 range ------ Command is invalid (Error Code “? “)-When LOGO LOCK is not in operationPIN CODE is within %1 range ------ Command is validPIN CODE is out of %1 range ------ Command is invalid (Error Code “? “)Note) Receiving correct LOGO PIN CODE while LOGO LOCK is in operationenables to change LOGO setting, but it does not release LOGO LOCK. (LOGOLOCK continues.)Projector returns Error Code “101” by receiving USER in %2 when capture has notoperated.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]