Sanyo PLC-WL2500A Manual

Also see for PLC-WL2500A: Owner's manual Manual Quick reference guide Owner's manual Specifications

Contents

Sanyo PLC-WL2500A Manual Manual pdf 42 page image

PLC-WL2500A / WL2501A/ WL2503A Expand Serial Command Functional Specifications41/728.10.24 CF_RCODE CommandCommand “CF_RCODE_%1”[CR]%1"001” --------------------------- Select Code1"002” --------------------------- Select Code2“UP” --------------- Switch Code setting of Remote Control forward“DN” -------------- Switch Code setting of Remote Control backwardNote) “UP” and “DN” behave the same.DetailsSelect Code of Remote ControlThe status set by this command is stored in EEPROM and its setting is effectiveafter ALL is OFFThis command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.25 CF_KEYDIS CommandCommand “CF_KEYDIS_%1”[CR]%1“NONE” ----------------------- RC & Projector keys are valid (All are valid)“RC” ---------------------------- RC keys are invalid“KEY” -------------------------- Projector keys are invalidDetails(This command is available to models with top panel buttons only.)Disable RC/Projector keysThis command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.26 CF_PJPINCODE CommandCommand “CF_PJPINCODE_%1”[CR]%1 “0000” – “9999” ---------Set PJ PIN CODE directlyDetailsSet PJ PIN CODE to release PJ LOCK.PIN CODE cannot be changed by this command.-When PJ LOCK is in operationPIN CODE is correct ------------------------- Command is valid (Acceptable)PIN CODE is incorrect ----------------------- Command is invalid(Error Code”102”)PIN CODE is out of %1 range ------------- Command is invalid (Error Code “? “)-When PJ LOCK is not in operationPIN CODE is within %1 range ---------------- Command is valid (Acceptable)PIN CODE is out of %1 range ---------------- Command is invalid (Error Code “? “)This command is valid during a dialog “PJ PIN CODE” is displayed after Power Onand Count down.Also when PJ LOCK setting is “On1”, it is necessary to transmit this commandevery time lamp turns on.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]