Sanyo PLC-WL2500A Manual

Also see for PLC-WL2500A: Owner's manual Manual Quick reference guide Owner's manual Specifications

Contents

Sanyo PLC-WL2500A Manual Manual pdf 56 page image

PLC-WL2500A / WL2501A/ WL2503A Expand Serial Command Functional Specifications55/729.7.8 CR_SYSTEM CommandCommand “CR_SYSTEM”[CR]Details Get selected SystemResponseAcceptable “000_%1”[CR]%1Input isPC Analog“VGA1” -------------- VGA1 is selected“VGA2” -------------- VGA2 is selected“XGA1”-------------- XGA1 is selected“WXGA3” --------- WXGA3 is selected“1080i” ------------ 1080i is selected“1035i” ------------ 1035i is selected“720p” ------------- 720p is selected“575p” ------------- 575p is selected“480p” ------------- 480p is selected“575i” -------------- 575i is selected“480i” -------------- 480i is selected“MODE1” ------- Mode1 is selected“MODE10” -------------- Mode10 is selectedWhen there is no signal, projector returns error code”101”[CR]Input isHDMI“D XGA1” ------------- D-XGA1 is selected“D WXGA3” ---------- D-WXGA3 is selected“D 1080I” ------------- D-1080i is selected“D 1035I” ------------- D-1035i is selected“D 720P” ------------- D-720p is selected“D 575P” ------------- D-575p is selected“D 480P” ------------- D-480p is selectedWhen there is no signal, projector returns error code”101”[CR]Input isY,Pb/Cb,Pr/Cr“AUTO” ----------- Auto is selected“1080i” ------------1080i is selected“1035i” ------------ 1035i is selected“720p” ------------- 720p is selected“575p” ------------- 575p is selected“480p” ------------- 480p is selected“575i” -------------- 575i is selected“480i” -------------- 480i is selectedProjector returns selected System status regardless of thesignal input.Input isVideo,S-Video“AUTO” --------------- Auto is selected“NTSC” --------------- NTSC is selected“NTSC443” ---------- NTSC4.43 is selected“PAL” ------------------ PAL is selected“SECAM” ------------- SECAM is selected“PAL M” ------------- PAL-M is selected“PAL N” ------------- AL-N is selectedProjector returns selected System status regardless of thesignal input.Unacceptable ““Error Code”[CR]