Sanyo PLC-WL2500A Manual

Also see for PLC-WL2500A: Owner's manual Manual Quick reference guide Owner's manual Specifications

Contents

Sanyo PLC-WL2500A Manual Manual pdf 39 page image

PLC-WL2500A / WL2501A/ WL2503A Expand Serial Command Functional Specifications38/728.10.13 CF_HDMI SOUND CommandCommand “CF_HDMI SOUND_%1”[CR]%1 “HDMI” ----------------------- Select PCM sound (Digital sound)“EXTERNAL” ------------- Select External sound inputDetailsSelect sound mode of HDMI setup.The status set by this command is stored in EEPROM and its setting is effectiveafter ALL is OFFThis command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.14 CF_TERMINAL CommandCommand “CF_TERMINAL_%1”[CR]%1 “COMPUTER” ----------------Set Input mode“MONITOR” ------------------- Set Monitor Out modeDetails Set Terminal setup. This command is available in normal Power ON status.Terminal means Computer 2 in this model.ResponseAcceptable “000”[CR]Unacceptable“Error Code”[CR]When Input is Computer 2, the projector returns “101” and thecommand is not executed.8.10.15 CF_STANDBYMODE CommandCommand “CF_STANDBYMODE_%1”[CR]%1 “ECO” ---------------------- Less standby electricity“NORMAL” --------------- Normal standby electricityDetails Switch Standby Mode setting.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.16 CF_P-MANE CommandCommand “CF_P MANE_%1”[CR]%1“OFF” --------------------------------- Set Power Management to OFF“READY” ----------------------------- Set Power Management to Ready“SHUTDOWN” --------------------- Set Power Management to Shut Down mode“UP” ------------------------------ Switch Power management setting(Off → Ready → Shutdown → Off)“DN” ------------------------------ Switch Power management setting(Off → Shutdown → Ready → Off)DetailsSet/Cancel Power ManagementThe status set by this command is stored in EEPROM and its setting is effectiveafter ALL is OFFThis command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]