Sanyo PLC-WL2503 Owner's Manual

Also see for PLC-WL2503: Command list Manual Manual Specifications Owner's manual

Contents

12Part Names and FunctionsTo ensure safe operation, please observe the following precautions :● Use two (2) AAA or LR03 type alkaline batteries.● Always replace batteries in sets.● Do not use a new battery with a used battery.● Avoid contact with water or liquid.● Do not expose the remote control to moisture or heat.● Do not drop the remote control.● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.● Risk of an explosion if battery is replaced by an incorrect type.● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.Open the batterycompartment lid.Install new batteriesinto the compartment.Replace thecompartment lid.Two AAA size batteriesFor correct polarity(+ and –), be surebattery terminals arein contact with pins incompartment.1 2 3Point the remote control toward the projector (InfraredRemote Receiver) when pressing the buttons. Maximumoperating range for the remote control is about 16.4'(5 m)and 60 degrees in front of the projector.Remote Control Operating RangeRemote Control Battery InstallationRemote Control CodeThe two different remote control codes (Code 1 - Code 2) are assigned to this projector. Switching the remotecontrol codes prevents interference from other remote controls when several projectors or video equipmentnext to each other are operated at the same time. Change the remote control code for the projector first beforechanging that for the remote control. See "Remote control" in the Setting Menu on page 54.Press and hold the MENU and IMAGE buttons for morethan five seconds to switch between the Code 1 and Code2. The initial code is set to Code 1.HDMIASPECTMENU buttonIMAGE buttonWhile pressing the MENUbutton, press the IMAGEbutton more than fiveseconds to switch betweenthe codes.16.4’(5 m)Downloaded From projector-manual.com Sanyo Manuals