Sanyo PLC-WL2503 Owner's Manual

Also see for PLC-WL2503: Command list Manual Manual Specifications Owner's manual

Contents

45Auto setupInput searchThis function detects the input signal automatically. Whena signal is found, the search will stop. Use the Point ▲▼buttons to select one of the following options.Off ......... Input search does not work.On 1....... Input search works under the following situation.– When pressing the AUTO SET button on theremote control.On 2....... Input search works under the following situation.– When turning on the projector by pressing theON/STAND-BY button.– When pressing the AUTO SET button on theremote control.– When the current input signal is cut off.** If the No show or Freeze function is active, cancelit to activate the Input search. It is also unavailablewhen On-Screen Menu is displayed.Auto PC adjOn. . . . . . . Enables Auto PC adjustment when pressingthe AUTO SET button on the remote control.Off . . . . . . Disables Auto PC adjustment.Auto setupNote:• While Input search function is set to On 1 or On 2, the status of Input and Lamp are displayed every time thesignal is switched.• Only the last selected input source can be detected.• If the COMPUTER 1/2 button, VIDEO, S-VIDEO, COMPONENT or HDMI button on the remote control ispressed during Input search is in progress, Input search will stop and go back to the previous input signal.• Auto PC adj. and Input search functions can not be set Off at the same time.• Fine sync, Total dots, Horizontal and Vertical positions of some computers can not be fully adjustedwith the Auto PC adjustment function. When the image is not provided properly with this operation, manualadjustments are required (pp.31-32).This function enables Input search and Auto PC adjustment bypressing the AUTO SET button on the remote control. Settingsfor those functions can be altered as follows:SettingDownloaded From projector-manual.com Sanyo Manuals