48CaptureCaptureThis function enables you to capture an image beingprojected to use it for a starting-up display or interval ofpresentations.Select Capture and press the SELECT button.A confirmation box appears and select yes to capture theprojected image.After capturing the projected image, go to the Logo selectfunction and set it to User. Then the captured image will bedisplayed the next time you turn on the projector.To cancel the capture function, select yes in the "Quit?"confirmation box.Note:• Before capturing an image, select Standard in theImage select Menu to capture a proper image (pp.33,40).• A signal from a computer can be captured up to WXGA(1280 x 800). A signal from video equipment can becaptured except for 720p, 1035i, and 1080i.• When capturing the image that has been adjusted bythe Keystone function, the adjusted data is automaticallyreset and the projector captures an image withoutkeystone correction.• When Logo PIN code lock function is set to On, Logoselect and Capture can not be selected.• When starting to capture a new image, the previouslystored image is cleared even if you cancel the capturing.• When there is no captured image or it is interruptedwhile capturing an image, User is not included in LogoSelect Menu, you can only switch between Default andOff.Logo PIN code lockThis function prevents an unauthorized person from changingthe screen logo.Off ........... The screen logo can be changed freely from theLogo Menu (p.47).On ........... The screen logo can not be changed without aLogo PIN code.If you want to change the Logo PIN code lock setting, pressthe SELECT button and the Logo PIN code dialog boxappears. Enter a Logo PIN code by following the steps below.The initial Logo PIN code is set to “4321” at the factory.Logo PIN code lockSettingNote:When Logo PIN code lock function is set to On, Logoselect and Capture can not be selected.Downloaded From projector-manual.com Sanyo Manuals