6. PROGRAMMING OPERATIONS EO1-111526.4 Store Name Message and Commercial Message Programming (Submode 1)6- 96.4 Store Name Message and Commercial Message Programming(Submode 1)Store Name Message and Commercial Message to be printed on the receipt can be programmed here.Any time outside a saleMode Lock: SET1 [X] |Line No.| [ST]Character Entries [ST] [AT/TL]NOTES: 1. For each line, a maximum of 32 regular-sized characters or 16 double-sized characters can beentered. A combination of both types is also available.2. When blanks are entered for the whole one line, it results in one line feed.3. If no commercial message is required on the receipt, program blanks for all three lines. As aresult no extra lines will be fed. If any one of the three lines is programmed, the two other lineswill cause line feeds.4. The 4-line range assigned for the store name/message will be either printed or fed, regardless ofany system option selection.5. If any incorrect characters have been programmed, depress the [C] key to clear all thecharacters on a line and then re-enter characters from the beginning, or end the line with an [ST]and re-program the entire line. The new data will be active.6. When all the lines have been programmed, do a check by issuing a receipt. Only the lines witherrors need to be re-programmed; other lines will not be affected.Example)To program the following Store Message and Commercial MessageMax. 32 characters/line(See Section 6.2 CharacterEntries.)1 digit (1 to 7)1 to 4: Store Name Message5 to 7: Commercial Message (For sequentially programming lines, theline number specification can be skipped.)Repeat for another line.To complete this line. To complete thisprogrammingoperation.OPERATIONCONDITIONLine No. 1Line No. 2Line No. 3Line No. 4Line No. 5Line No. 6Line No. 7T E C S T O R E1 3 4 3 P E A C H D R I V EP H O N E : 8 7 - 6 4 3 7O p e n 8 : 0 0 a m t o 7 : 0 0 p mC l o s e d : e v e r y W e d n e s d a yStore Name/MessageportionCommercial Messageportion
