5. PROGRAMMING OPERATIONS EO1-111525.1 Programming Operations Common with Standalone ECR Level5- 15. PROGRAMMING OPERATIONSThe system should be programmed fully by your local TOSHIBA TEC representative at the time of deliveryaccording to the user’s requirements so that daily operations can immediately start. However, some data must beadded or changed daily or in a longer period. Since the volume of programming contents for the system is toolarge, this chapter and the following two chapters are provided as guide lines of the user’s daily programming andmaintenance operations. If there are any unclear points or program data other than listed here must be changedor added, please contact your TOSHIBA TEC representative. Please also note that some programmingoperations introduced in the Standalone Level are modified or not available on in-line terminals.5.1 Programming Operations Common with Standalone ECR LevelThe following is the table of programming operations which are introduced in the Manager’s Guide for theStandalone Level and can be operated on in-line terminals as well, with the Submode No. and operationsequence unchanged. However, on in-line terminals, these are usually operated on the Master Terminal onlyand down-line-loaded (DLLed) to all the Satellite Terminals. Therefore, if any program data is changed, a DLL isfurther necessary to load the new data (after the change) to all the Satellite Terminals (to be described in Chapter6).PROGRAMMING JOB LISTMaster *1: Programming job to be available when the [RTR] key is activated on the Master TerminalSatellite*2: Programming job to be available on the Backup Master Terminal and the Satellite Terminal when the[RTR] key is off on the Master TerminalO: AvailableTerminalsSubmodeNo. Programming Job Master*1 Satellite*21 Store Name/Message and Commercial Message Programming O O2 Cashier Code and Name Programming O4 PLU Table Programming O5 Time Setting or Adjustment O O6 Date Setting or Adjustment O O8 Amount Limit Setting for Function Keys O O15 Customer File Code (Check Track No.) and Name Programming O20 Salesperson Code and Name Programming O25 Link PLU Table Programming O26 Tare Table and General Unit Weight Setting O27 PLU Preset-code Key Setting O O31 Display Message Programming O O35 Negative Amount Key Limit Amount Setting O40 PLU Price Dollar Discount/Extra Charge Amount Setting ODepartment Preset Price Setting or Changing OPLU Preset Price Setting or Changing,Whole Package Quantity Changing O%+ and %- Preset Rate Setting O OPreset Rate Setting for Selective Itemizers O OForeign Currency Exchange Rate Setting OTax Table Programming ONoSubmodeStore/Register No. Setting O O
