June 2003 IPN: M5000-00-105 Disassembling the radio D - 5Figure D-3: Removing the front panel from the chassis, using the battery as leverageRemoving the shield sub-assemblyfrom the chassisRemove the plastic speaker pins. Place theradioís internal assembly on a flat surface withthe shield side facing up toward you. Presslightly down on the shield sub-assembly abovethe slot clip detail (shown in Figure D-4),which will slightly bow the shield away fromthe chassis.Maintain pressure and insert a flat bladedscrewdriver (approximately 4 mm) in the gapbetween the shield and the chassis. Twist thescrewdriver and the shield should rise up overthe clip.Figure D-4: Removing the shield sub-assembly fromthe chassisbattery packfront panelchassisshield1234microphone grommet protruding from the shieldgrip battery here, gently pull away from the front panelpull radio out and away from the front panel at this point567remove speaker pinsshieldchassisslot clip detailapply pressure hereinsert screw driver here and twist1234561345562
