Set The Top Of Form167ZTP MenuThe ZTP menu includes the ability to enable and disable features unique tothe Zero Tear printer (ZTP), set the tear bar distance, set the auto presentdata time, and set the auto present wait time. This section defines theseoptions.ZTP Data TimeThis option sets the pause time in the data stream that the ZTP requiresbefore moving the form to the tear bar once a print job is completed. Thevalues range from .5 to 15 seconds. The default is .5 seconds.ZTP Wait TimeThis option sets the minimum amount of time that the form stays at the tearbar. This allows you time to remove the form before the form is retracted toprint the next form. The adjustable values range from 1 to 10 seconds inincrements of 1 second. The default value is 2 seconds.ZTP TearDistanceThis option sets the tear off distance from the current print position to the tearbar. Adjustable values in increments of 1/144th of an inch range from 200 to2880. The up and down arrows adjust the display value. When you press theEnter key, the selected value is stored and a scale is printed to indicate thecurrent tear off position. The default value is 1060.NOTE: When a new value is selected, the printer will lose the current printposition. You must reset the top of form to automatically save the newvalue.ZTP Platen OpenThis option allows the user to have the platen open whenever forms arereversed. Enabled is the default, used for most papers and labels. The featurecan be disabled as required by some multi-part forms.ZTPMenu 1(from page 53)ZTPFunctionZTPTearDistanceZTPData TimeZTPWait TimeZTPPlaten OpenEnable*Disable1060/144 Inch*.5 Sec*0.5 - 15 Sec2 Sec*1 - 10 SecEnable*Disable* = Factory Default1 Available for Zero Tear Pedestal printers only.