76Chapter 4 Config MenuCode 7FThis parameter allows you to dictate how the printer will react when it receivesa Hexadecimal code 7F. The default value depends on the emulation.(See the Emulation Parameter, page 54.).• Ignore. The code is ignored.• Delete Char (default). The previous character is deleted.• Delete Buffer. The previous characters on the current print line aredeleted.• Space. A Space character is substituted.• Fill. A Fill character is substituted.Print 80 to 9F HexThis parameter defines whether locations 80 through 9F Hex are to be treatedas control characters or printable characters. The function of the controlcharacters in this area depends on the emulation. The selections are ON(printable characters) or OFF (control characters). The default value dependson the emulation.Ignore CharThis parameter allows you to select a character that will be ignored in theincoming data stream. This parameter functions in all emulations andnondownloadable print modes. It does not function in plot mode, fontdownload, or VFU download. Selections are 0-255, referring to the decimalvalue of any 8-bit character, or OFF. Default is OFF.Sub Char FromThis parameter allows you to select a character that will be replaced by thecharacter designated by the Sub Char To parameter. This parameterfunctions in all emulations and non-downloadable print modes. It does notfunction in plot mode, font download, or VFU download. Default is OFF.Sub Char ToThis parameter allows you to select the character that will replace thecharacter designated by the Sub Char From Parameter. This parameterfunctions in all emulations and non-downloadable print modes. It does notfunction in plot mode, font download, or VFU download. Default is OFF.PTX SFCCDefines the Special Function Control Character used by the Printronix P5000emulation. The decimal value of the ASCII character code is entered. Thedefault value is 1 (SOH).
