Codes Submenu73• Power up. This produces a complete printed report of the power-upprinter configuration. The report contains a header which identifies theinstalled software and interface, and any options that are installed.• All. This produces a complete printed report of all saved printerconfigurations. Each report contains a header which identifies theinstalled software and interface, and any options that are installed.• 1-8. This produces a complete printed report of any of the saved printerconfigurations. Each report contains a header which identifies theinstalled software and interface, and any options that are installed.• Intellifilter. Prints the currently downloaded Intellifilter.Codes SubmenuCODES(from page 70)Auto LF Auto CR Line Wrap WrapLine FeedPrint on CR Form FeedAt TOFOff*OnOnOff*OnOff*OnOff*Off*Double StrikeBoldEnable*Disable* = Factory Default1 If P5000 emulation is selected2 If Genicom ANSI emulation is selectedESCEnable*DisableAlt ESCDisable*EnableUpperOnlyDisable*EnableCode 7FIgnoreDelete CharDelete BufferSpaceFill*Print80 to 9F HexOn*OffIgnoreCharOff*0-255Sub CharFromOff*1-255Sub CharToOff*1-255PTX SFCC 11*0-255PTX ALS 18*10.3TOF ControlEnable*DisableDC3OperationEnable*DisableSISOOverszBar 2Disable*EnableBarcodTop Pos 2Enable*DisableOverszTop Pos 2Enable*Disable
