Tascam DP-004 Owner's Manual

Also see for DP-004: Manual Maintenance Instructions

Contents

IMPORTANT SAFETY INSTRUCTIONSTASCAM DP-004 3The unit power should be off when you install and replace batteries.•Remove the batteries if you do not plan to use the unit for a long time.•Batteries could rupture or leak, causing fire, injury or stains around them. Ifthe battery fluid leaks, wipe away any fluid on the battery case before insert-ing new batteries.FOR U.S.A.TO THE USERThis equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to Part 15 of the FCC Rules. These limitsare designed to provide reasonable protection against harmful interferencein a residential installation. This equipment generates, uses, and canradiate radio frequency energy and, if not installed and used in accordancewith the instruction manual, may cause harmful interference to radiocommunications. However, there is no guarantee that interference willnot occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correctthe interference by one or more of the following measures.a) Reorient or relocate the receiving antenna.b) Increase the separation between the equipment and receiver.c) Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.d) Consult the dealer or an experienced radio/TV technician for help.CAUTIONChanges or modifications to this equipment not expressly approved byTEAC CORPORATION for compliance could void the user's authority tooperate this equipment.Declaration of ConformityModel Number : DP-004Trade Name : TASCAMResponsible party : TEAC AMERICA, INC.Address : 7733 Telegraph Road, Montebello,California, U.S. A.Telephone number : 1-323-726-0303This device complies with Part 15 of the FCC Rules. Operation is subjectto the following two conditions: (1) this device may not cause harmfulinterference, and (2) this device must accept any interference recieved,including interference that may cause undesired operation.