TASCAM DP-008 27Rear panelz FOOT SWITCH jackYou can use a foot switch to punch in andout (start and stop recording).x INPUT B jack (1/4” phone jack)Use this as the input source by settingINPUT B to external input (“Ext.Input”) on the INPUT SETTING screen.You can use this jack for a line level ormic level signal (unbalanced connection).c INPUT A jack (1/4” phone jack)Use this as the input source by settingINPUT A to Ext. Input (external input)on the INPUT SETTING screen. You canuse this jack for a guitar/line level or miclevel signal (unbalanced connection).Set the MIC/LINE–GUITAR switchaccording to the input source.v MIC/LINE-GUITAR switchSet this switch to match the input signalto the INPUT A jack on the rear panel. Formic or line signals, set it to MIC/LINE.For electric guitars and basses that areconnected directly, set it to GUITAR.b INPUT A/INPUT B jacks (XLR jacks)Condenser microphones that requirephantom power can receive it whenthey are connected to these jacks. (See“Phantom Power” on page 41.)(Pin assignments—1: ground, 2: hot, 3:cold)If devices are connected to both theXLR and the 1/4” phone jacks, the 1/4”phone jack is given precedence (the XLRconnection is disabled).n LINE OUT jacksUse these to connect a monitoring system(powered speakers or an amplifier withspeakers).m PHONES jackConnect headphones (with a stereo mini-plug connector) to this jack., VOLUME dialUse this to adjust the volume output fromthe PHONES connector.3 – Names and Functions of Parts
