Tascam HS-4000 Owner's Manual

Also see for HS-4000: Owner's manual New features Release notes

Contents

126 TASCAM HS-400013 – Other functionsRequired settings when connecting by FTPThe following settings are necessary when connecting to thisunit by FTP.IP address: This unit's IP address is shown in the IPAddress field of the REMOTE SETUP screenETHERNET page.Port number: 21User name: HS-4000 (case sensitive, cannot be changed)Password: The default password is "HS-4000". Thepassword is case sensitive and can bechanged by using the Password Changebutton on the REMOTE SETUP screenETHERNET page.NOTE• The number of simultaneous connections should be "1".• Depending on the FTP client application, two simultaneousconnections with this unit might be possible, but files mightnot be transferred correctly, so you should not use two ormore simultaneous FTP connections with this unit.• FTP connections cannot be made when the EXT. CTRL itemhas been set to LOCK on the LOCK SETUP screen. When anFTP connection is active, setting this to LOCK will end theconnection.• When an FTP connection is active, changing any settingson the REMOTE SETUP screen ETHERNET page will end theconnection.Working with files using an FTP client application• Reading files from the unitYou can read files from this unit at any time.• Adding new files to the unitYou can add new files to this unit at any time.When recording, if you add BWF or WAV files to the currentsession, they will be shown in the list with existing files,recorded files and added files in that order.• Overwriting existing files on the unitYou can only overwrite the current take when the unit isstopped.You cannot overwrite a take that is currently in use on theplaylist mode entry editing screen. You can overwrite otherexisting files at any time.However, if the PLAY SETUP screen GENERAL page PlayMode item is set to All Take, overwriting the take followingthe current take during playback might not be possibledepending on the timing.CAUTION• In playlist mode, if you overwrite a take that has beenadded to a playlist as an entry, a “?” will be shown for thecorresponding entry on the ENTRY list and file ASSIGNscreens, and that file will be ignored for playback. To enableplayback of a file that has overwritten another, add theoverwritten file as an entry.• In On-Air mode, if you overwrite a file shown on the onair list screen, the corresponding take will be uncheckedand the file will be ignored for playback. Rebuild when thefollowing rebuild confirmation message is shown.When you rebuild, all the takes will be enabled for playback(checked), so deselect any that you do not want to be playedback.• If overwriting causes the size, number of channels, bit-rateor sampling frequency of an audio file to be different fromthe previous file, inconsistencies could occur in the existingtimeline or playlist.If such an inconsistency occurs, the following error messagemight appear when you start playback.Conduct the following to eliminate the inconsistency andstop the error message from occurring.Timeline mode: Erase the affected region.Take mode: Delete the affected take from the CF card.Playlist mode: Add the overwritten file as an entry.On-air mode: Rebuild using the Home Screen pull-downmenu REBUILD button.• Do not overwrite an existing audio file with a file that usesa different sampling frequency. The inconformity will beunresolvable.3. Deleting files on the unitThe current take can be deleted only when the unit isstopped.Files other than the current take can be deleted at any time.However, deleting files will cause inconsistencies betweenthe system files and audio files, so it is necessary to rebuildafter deleting a file.• After deleting a file (and stopping playback orrecording), the following rebuild confirmation messagewill appear. Touch OK to rebuild.• If you do not rebuild, inconsistencies between thesystem files and audio files will occur and a message likethe following might appear.