Tascam HS-4000 Owner's Manual

Also see for HS-4000: Owner's manual New features Release notes

Contents

72 TASCAM HS-40008 – Take modeBWF-J cue points (take mode)When the Follow BWF-J item on the GENERAL page of the PLAYSETUP screen is ON, if a BWF-J cue point is detected duringplayback, the following operations will occur. In addition, whenthe BWF-J tally item on the PARALLEL page of the REMOTESETUP screen is ON, cue signals and tally signals will be outputfrom the parallel remote connector in response to each BWF-Jcue point.BC$STANDBYWhen a take is loaded, the transport locatesto this point as the playback start point.During playback, when this point is reached,playback standby starts. In either case, aBC$STANDBY tally is output.BC$CM During playback, when this point is reached,a BC$CM CUE signal is output.BC$END During playback, when this point is reached,a BC$END CUE signal is output.BC$STOPDuring playback, when this point is reached,a BC$STOP CUE signal is output, andplayback stops.BC$FILEDuring playback, when this point is reached,a BC$END cue signal is output, and if thenext take has a BC$STANDBY cue point, thetransport locates to that point, playbackstandby starts and a BC$STANDBY tally isoutput.BC$PAUSEDuring playback, when this point is reached,a BC$PAUSE tally is output, and playbackstandby starts.Using the flash start function in playlistmodeUsing a TASCAM RC-HS32PD (sold separately) or other remotecontroller, flash start playback is possible.For details, see “Flash start function” on page 123.Take operationsYou can create multiple takes in the same session folder.For details, “5 – Projects” on page 36.The following operations are possible with takes.p Changing take start timesp Adding @ marks to take names and removing themp Copying takesp Deleting takesp Sorting takesp Moving takesp Editing take namesChanging the start time of a take1. Press the PROJECT key on the front panel to open thePROJECT screen.2. Touch the e button for the project that contains the takefor which you want to edit the start time to open the sessionselection screen.If it is not the current project, a pop-up window appearsconfirming that you want to load it. Touch the OK button.3. Touch the e button for the session that contains the takefor which you want to edit the start time to open the takeselection screen.If it is not the current session, a pop-up window appearsconfirming that you want to load it. Touch the OK button.NOTETo load a take in the current session, instead of steps 1to 3, you can do one of the following to move to the takeselection screen of the current session.• Touch the session name button at the top right of theproject screen.• Touch the take name button on the Home Screen toopen a pull-down menu and touch the TAKE List button.• Touch the session/take name in the lower informationarea of the HOME screen when the INFO button ispressed.4. Select the take that you want to edit the start time.5. Touch the MENU button on the take selection screen toopen a pull-up menu.6. Press the EDIT TC button in the pull-up menu to open theTAKE TC screen.