TASCAM HS-4000 677 – Timeline modeBouncingYou can output part of a region or an interval that crossesmultiple regions as a single take.Designating the bounce starting point1. Touch the HOME key to open the Home Screen.2. Use the m and , keys, for example, to locate thebounce start point (time).3. Touch the Bounce I/O button to open a pull-up menu withbuttons related to bouncing.4. Touch the SET IN button on the pull-up menu to set thebounce starting point (IN point).The IN mark ( ) appears at the current position in the markdisplay area.Designating the bounce ending point5. Use the m and , keys, for example, to locate thebounce ending position (time).6. Touch the BOUNCE I/O button to open a pull-up menu.7. Touch the SET OUT button on the pull-up menu to set thebounce ending point (OUT point).The OUT mark ( ) appears at the current position in themark display area.Selecting tracks8. If "TIMELINE Rec Tracks" is set to "2trx2", touch the tracks thatyou want to bounce to select them.Bouncing the interval9. Touch the BOUNCE I/O button to open a pull-up menu.10. Touch the BOUNCE button on the pull-up menu to open theBOUNCE NAME screen where you can input the bounce filename.Input the file name. Use the same input method as in“Editing the project name” on page 40.11. Press the Enter button. The following confirmation pop-upmessage will appear.• Touch the Root dir button to save the bounce to the rootfolder of the current CF card.• Touch the Current Session button to save the bounce tothe current session.• Touch the Cancel button to return to the BOUNCE NAMEscreen without bouncing.While the file is being created, a progress status pop-upappears.When file creation completes, the pop-up disappears.NOTEYou can cancel a bounce by pressing the CANCEL buttonwhile the progress pop-up window is open.Clearing the bounce starting and ending points12. Touch the Bounce I/O button to open a pull-up menu withbuttons related to bouncing.13. Touch the CLEAR button on the pull-up menu to discard thecurrently set IN and OUT points.When a confirmation message pop-up appears, touch theOK button or press the DATA dial. The IN ( ) and OUT ( )marks in the mark display area will disappear.
