53OPERATING MANUALVERSION 05/2017 ORDER NUMBER DOC 2354920 SPRINT XE8.3.2 60 L TANK VERSIONP_01785EPG SPRINT X0 %1020304050Ø12101198m /h2.03.00.50.30.11.535.54.53.52.580100 %Tri9060706524P_0114071388910P_0114117Procedure:1. Release the trigger on the spray gun.The high voltage and the powder feed aredeactivated.2. Remove powder injector (1) from holder (2).3. Hold the gun in the spray booth and start theflush function by pressing the "Flush" button (17).The injector and hoses are flushed.4. Switch off control unit.5. Release the union nut on powder feed hose(3) and disconnect powder feed hose (3) frominjector (1).6. Disconnect the red feed air hose (4) from injector(1).7. Disconnect the blue dosing air hose (5) from theinjector (1).8. Check powder injector for wear and replaceworn parts if necessary.The wearing and spare parts can be found in thepowder injector's operating manual.9. Loosen the exhaust air hose (6) from theconnection (7) of the powder tank (8).10. Pull the black fl uid air hose (9) off the powdertank (8).11. Loosen the grounding cable (10) from thepowder tank (8).12. Lift the powder tank off from the equipmenttrolley for cleaning.13. Open the lid of the powder tank to empty thepowder tank and thoroughly blow out thepowder tank.14. Completely remove all residual powder from thesuction system.15. Pay special attention when cleaning the fluidbase, check it for blockage or damage andreplace it if necessary.The wearing and spare parts are in the "SpareParts" chapter of this operating manual.
