                                                                                                |
WAGO-SPEEDWAY 767 Mounting 39767-5203 Serial Interface (RS-232, RS-422/-485)ManualVersion 1.1.0Pos : 22.26 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/I/O-M odule/Montage_Besc hriftung austauschen 767- xxxx allgemein @ 5\mod_1249034032812_21.doc x @ 39780 @ 2 @ 14.6 Marking and Replacing the Marking SpacesThe module marker card (10) and marking strip (12) are attached when delivered.The protective cover is to be removed when labeling the marking strip. To do this,proceed as follows:1. Press the slot screwdriver (maximum slot width: 3mm) into the smallopening under the marking strip cover (12) and lever it up.2. Remove the marking strip cover.3. Mark the marking strip with a waterproof pen.4. Reinsert the marking strip cover and press it firmly in place.If the module's marker card (10) must be replaced, proceed in accordance with thestep sequence described previously. New module marker cards can be obtainedthrough WAGO.Pos : 22.27 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/I/O-M odule/Montage_Besc hriftung austauschen 767- xxxx_4xM12 - Bild @ 5\mod_1249284529218_21.doc x @ 39825 @ @ 1Figure 12: Replacing the marking spacesPos : 22.28 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 11012 |
Related manuals for WAGO SPEEDWAY 767 Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine