WAGO SPEEDWAY 767 Series Manual

Also see for SPEEDWAY 767 Series: Manual Manual Manual Manual Manual

WAGO-SPEEDWAY 767 Service 81767-5203 Serial Interface (RS-232, RS-422/-485)ManualVersion 1.1.0Pos : 52 /Serie 767 ( WAGO-SPEED WAY)/Ser vic e/I/O-M odule/Ser vic e 767- xxxx allgemein 2.2 @ 8\mod_1278649957222_21.doc x @ 59430 @ 3 @ 111.2.2 Removing the Module from Your SystemTo remove the module from your system's framework, proceed as follows:1. Disconnect the power supply from those devices on which you havemounted the module.2. Release the module from your system by unscrewing the M4 screws.Pos : 53 /Serie 767 ( WAGO-SPEED WAY)/Ser vic e/I/O-M odule/Ser vic e 767- xxxx allgemein 3 @ 5\mod_1249469687968_21.doc x @ 40445 @ 3 @ 111.2.3 Removing the Module from the Carrier RailIn order to keep the representation unambiguous, the carrier rail adapter in thefollowing figure (B, C) is shown without module.If the module is mounted on a carrier rail, proceed with the removal as follows:1. Disconnect the power supply from those devices on which you havemounted the module.2. To remove the module, press down the release actuator of the carrier railadapter using a slot screwdriver (B) and remove it from the carrier rail (C).Pos : 54 /Serie 767 ( WAGO-SPEED WAY)/Ser vic e/I/O-M odule/Ser vic e 767- xxxx_M12 allgemein2 - Bild @ 5\mod_1249471167718_21.doc x @ 40463 @ @ 1Figure 23: Removing the module (with the carrier rail adapter) from the carrier railPos : 55 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1A B C