WAGO SPEEDWAY 767 Series Manual

Also see for SPEEDWAY 767 Series: Manual Manual Manual Manual Manual

WAGO-SPEEDWAY 767 Parameterizing 57767-5203 Serial Interface (RS-232, RS-422/-485)ManualVersion 1.1.0Pos : 31.9 /Serie 767 (WAGO-SPEED WAY)/Par ametrieren/I/O-M odule/Parametri erung 767- 5203, - 5204 Gl obal e Di agnosen @ 12\mod_1329213581568_21.doc x @ 88880 @ @ 1Table 30: Information about existing module diagnosticsGlobal DiagnosticsDiagnostics DescriptionLow voltage ULSDisabling the outputsIf there is an undervoltage of U A and/or U LS , the module outputs aredisabled. Machine components can be placed in a dangerouscondition, as well as personnel and machine put in danger.If an undervoltage of the logic and sensor supply (U LS) of < 18 Voccurs on the module, the outputs are disabled and a correspondingdiagnostic is transmitted to the fieldbus coupler.The serial interfaces are disabled.The F-LED of the module illuminates.Low voltage U ADisabling the outputsIf there is an undervoltage of U A and/or U LS , the module outputs aredisabled. Machine components can be placed in a dangerouscondition, as well as personnel and machine put in danger.If an undervoltage of the actuator supply (U A) of < 18 V occurs on themodule, the outputs are disabled and a corresponding diagnostic istransmitted to the fieldbus coupler.The serial interfaces are disabled.The F-LED of the module illuminates.Pos : 31.10 /Serie 767 ( WAGO-SPEED WAY)/Parametrier en/I/O-Module/Parametrier ung Global e Di agnosen Kurzschl uss /Überlas t und U nterbr echung Fel dversorgung @ 8\mod_1278394655719_21.doc x @ 59061 @ @ 1Short circuit/ overloadencoder supplyThe module has detected a short circuit or overload of the encodersupply (only possible when field supply is switched on).Pos : 31.11 /Serie 767 ( WAGO-SPEED WAY)/Parametrier en/I/O-Module/Parametrier ung Kanaldi agnosen Ü bertemper atur @ 7\mod_1268294869501_21.doc x @ 52378 @ @ 1Table 31: Information about existing channel diagnosticsChannel DiagnosticsDiagnostics DescriptionOvertemperature The module has identified overheating on the corresponding channel(1 – 8) (only enabled when the actuator output is switched on).Pos : 31.12 /Serie 767 ( WAGO-SPEED WAY)/Wichtige Erläuter ung en/Sic herheits hinweise/Hinweis/Hi nweis : U nterbrechung S-BU S 48er @ 8\mod_1278393489593_21.doc x @ 59044 @ @ 1Interruption of the S-BUSIf there is an interruption of the S-BUS, the module is automatically put in STOPmode. The module outputs are disabled.Pos : 31.13 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1