                                                                                                |
60 Parameterizing WAGO-SPEEDWAY 767767-5203 Serial Interface (RS-232, RS-422/-485)ManualVersion 1.1.0Table 33: Overview of adjustable parameters for the digital outputsParameter DescriptionRestart delay, actuator Time in 100 ms intervals, after which a disabled output is switched onagain in case of error.You must deactivate the checkbox under "Restart mode, actuator" (0).Default setting: 10 * 100 ms = 1000 msNote:If you set the time of the "Restart delay, actuator" parameter to 0 ms, theI/O LED appears yellow instead of red if a short circuit or overloadappears due to the short restart interval (see section "Diagnostics").Overtemperature When the checkbox is activated, there is an overtemperature on therespective channel (only enabled when the actuator output is switchedon).* Default** The last value is the value output to the contact before occurrence of the respective interruption.For example, this can be a process value or "manual operation value". |
Related manuals for WAGO SPEEDWAY 767 Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine