42 Connect Devices WAGO-I/O-SYSTEM 750750-657 IO-Link MasterManualVersion 1.0.2, valid from FW/HW-Version 02/01Pos: 73 /Alle Serien (Allgemeine Module)/Überschriften für alle Serien/Anschließen/Geräte anschließen - Überschrift 1 @ 3\mod_1234172889468_21.doc @ 27460 @ 1 @ 18 Connect DevicesPos: 74 /Serie 750 (WAGO-I/O-SYSTEM)/Anschließen/Leiter an CAGE CLAMP anschließen - Überschrift 2 und Text @ 3\mod_1225448660171_21.doc @ 24928 @ 2 @ 18.1 Connecting a Conductor to the CAGE CLAMP ®The WAGO CAGE CLAMP® connection is appropriate for solid, stranded andfinely stranded conductors.Only connect one conductor to each CAGE CLAMP® connection!Only one conductor may be connected to each CAGE CLAMP® connection.Do not connect more than one conductor at one single connection!If more than one conductor must be routed to one connection, these must beconnected in an up-circuit wiring assembly, for example using WAGO feed-through terminals.Exception:If it is unavoidable to jointly connect 2 conductors, then you must use a ferrule tojoin the wires together. The following ferrules can be used:Length 8 mmNominal cross section max. 1 mm2 for 2 conductors with 0.5 mm 2 eachWAGO Product 216-103 or products with comparable properties.1. To open the CAGE CLAMP® insert the actuating tool into the openingabove the connection.2. Insert the conductor into the corresponding connection opening.3. To close the CAGE CLAMP® simply remove the tool - the conductor isthen clamped firmly in place.Figure 15: Connecting a conductor to a CAGE CLAMP®Pos: 75 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
