Xerox DocuPrint 92C Installation Planning Manual

Also see for DocuPrint 92C: Message guide Quick reference card Quick reference card Troubleshooting guide Quick reference card

Contents

Xerox DocuPrint 92C Installation Planning Manual Manual pdf 84 page image

INSTALLATION8-2 XEROX DOCUPRINT NETWORK PRINTER SERIES INSTALLATION PLANNING GUIDE FOR MODEL 92C NPS5. Xerox personnel conducts initial operations training (2 to 4hours).6. Xerox personnel reviews preventive maintenance schedulesand service call procedures.Your responsibilitiesXerox is responsible for the physical installation of the printercomponents and for loading the software and applications. You havethe general site responsibility of ensuring that the right personnel,supplies, and network information are available.At the time of installation, you should do the following:• Make sure that your system administrator is available during theloading of software.• For software loading purposes, be prepared to provide Xeroxpersonnel with network information from the preinstallationchecklist. Refer to the “Setting up the work area” chapter of thisguide for specifics regarding network information.• Designate two client workstations for downloading Xerox clientsoftware if applicable: one for initial system validation andanother for use in operator training provided by your systemsanalyst.• Check the documentation and software kits with their packinglists for completeness.• Load Xerox client software on any additional clientworkstations.Remember that you are responsible for supplying, installing,and maintaining your client workstations and the Token Ringnetwork or Ethernet local area network (LAN) that connectsthem with the Printer Controller. You are also responsible for theEthernet, Token Ring, and FDDI connectors required for yoursystem.• Have test jobs ready to run.• Have your operators available for training.Refer to the installation planning checklist in the “Setting up the workarea” chapter of this guide for a complete list of responsibilities.