O S / 2 7Step-by-Step Setup for IBM TCP/IP for OS/2TCP/IP Protocol Configuration1. Acquire two IP addresses for use on your server and yourXEROX DocuPrint printer.2. Install TCP/IP for OS/2. Remember to open Lan Adapter andProtocol Support (LAPS/MPTS, etc) and configure the TCP/IPprotocol for your network adapter. (See your OS/2 documentationfor configuring network adapters for the TCP/IP protocol.)3. Open (double-click) TCP/IP Configuration Object.• Click Printing TAB and enter the following:• REMOTE PRINT SERVER = Printer IP Address in 32-bitdotted decimal notation (e.g. 127.0.0.0).• REMOTE PRINT SERVER’S PRINTER = ps (Enter“ps”, without quotes and in lowercase.)• MAXIMUM NUMBER OF LPD PORTS = Enter anumber between 2 and 64 inclusive.• FOR OS/2 PRINTING ONLY (NO WIN-OS/2) Click theAutostart TAB. Highlight lprportd, then click AutostartService, Foreground Session, and Minimized.• Close the TCP/IP Configuration windows. Click SAVE,then reply YES to Update CONFIG.SYS.• Shutdown your server/workstation and reboot.NOTE: Once completed and you have rebooted, use the “ping “command at an OS/2 Command Prompt to ping yourserver/workstation’s IP address. Repeat the ping command using yourDocuPrint printer’s IP Address to confirm that your printer isconfigured properly for using TCP/IP.
