307 Faxing (DocuPrint M205 f/M205 fw Only) Available Fax Setting OptionsYou can use the following setting options for configuring the fax system:Option DescriptionAns Select TEL Mode Automatic fax reception is turned off. You can receive a fax bypicking up the handset of the external telephone, pressing theremote receive code, and then pressing the (Start) button.FAX Mode * Automatically receives faxes.TEL/FAX Mode When the printer receives an incoming fax, the externaltelephone rings for the time specified in Auto Ans.TEL/FAX, and then the printer automatically receives a fax. Ifan incoming call is not a fax, the printer beeps from theinternal speaker indicating that the call is a telephone call.Ans/FAX Mode The printer can share a telephone line with an answeringmachine. In this mode, the printer will monitor the fax signaland pick up the line if there are fax tones. If the phonecommunication is using serial transmission in your region, thismode is not supported.DRPD Mode Before using the Distinctive Ring Pattern Detection (DRPD)option, a distinctive ring service must be installed on yourtelephone line by the telephone company. After the telephonecompany has provided a separate number for faxing with adistinctive ring pattern, configure the fax setup to monitor forthat specific ring pattern.Auto Answer Fax Sets the interval at which the printer goes into the fax receive mode after receivingan incoming call.Auto Ans.TEL/FAXSets the interval at which the printer goes into the fax receive mode after theexternal telephone receives an incoming call.Auto Ans.Ans/FAXSets the interval at which the printer goes into the fax receive mode after theexternal answering machine receives an incoming call.Line Monitor Sets the volume of the line monitor, which audibly monitors a transmission throughthe internal speaker until a connection is made.Ring ToneVolumeSets the volume of the ring tone, which indicates that an incoming call is a telephonecall through the internal speaker when Ans Select is set to TEL/FAX Mode.Line Type Sets the line type.Dialing Type Sets the dialing type.NOTE:• This menu is not displayed when Region is set to Australia.Interval Timer Specifies the interval between transmission attempts.Number of Redial Specifies the number of redial attempts to make when the destination fax number isbusy. If you enter 0, the printer will not redial.Redial Delay Specifies the interval between redial attempts.Junk Fax Filter Sets whether to reject faxes sent from unwanted numbers by accepting faxes onlyfrom the fax numbers registered in the Address Book.Remote Receive Sets whether to receive a fax by pressing a remote receive code on the externaltelephone.Remote Rcv Tone Specifies the remote receive code in two digits to start Remote Receive.Send Header Sets whether to print the information of sender on the header of faxes.
