Using the Operator Panel Menus and Keypad 330• Power Saving TimerPurpose:To specify the time for transition to the Power Saver mode.Values:Enter 1 in Low Power Timer to put the printer in the Low Power mode one minute after it finishes ajob. This uses less energy, but requires more warm-up time for the printer. Enter 1 if your printershares an electrical circuit with room lighting and you notice lights flickering.Select a high value if your printer is in constant use. In most circumstances, this keeps the printerready to operate with minimum warm-up time. Select a value between 1 and 30 minutes for the LowPower mode if you want a balance between energy consumption and a shorter warm-up period.The printer automatically returns to the standby mode from the Power Saver mode when it receivesdata from the computer. In the Low Power mode, you can also return the printer to the standby modeby pressing any button on the operator panel. In the Sleep mode, you can return the printer to thestandby mode by pressing the (Energy Saver) button.• Auto ResetPurpose:To automatically reset the settings for copying, scanning, or faxing to the defaults and return to thestandby mode after you do not specify any settings for the specified time. (The fax feature is availableonly on the DocuPrint M205 f/M205 fw.)Values:• Fault Time-OutPurpose:To specify the time taken by the printer before it cancels jobs that stop abnormally. The job iscancelled if it times out.Values:Low Power Timer 1min* Specifies the time taken by the printer before it enters the LowPower mode after it finishes a job.1-30minSleep Timer 10min* Specifies the time taken by the printer before it enters theSleep mode after it goes into the Low Power mode.6-11min45sec*1min2min3min4minOff Disables the fault time-out.On 60sec* Specifies the time taken by the printer before it cancels for jobsthat stop abnormally.3-300sec
