General Troubleshooting 3-55Finisher Stack Handling Motor FailureThe Delivery Belt Home Position Sensor detected a Stack Handling error.Applicable Status Code:Code F111: Stack Handling Motor FailureInitial Actions:■ Cycle the printer's power.■ If the problem persists follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack References■ Finisher Stack Handling Motor■ Finisher Control Board■ Options Map 1 Finisher Controller Board■ Options Finisher Controller to MotorsTroubleshooting Procedure TableStep Actions and Questions Yes No1 Check the delivery mechanism.Does the Delivery Belt turn freely whenoperated manually?Go to Step 2. Repair themechanism.2 Test the Delivery Belt Home PositionSensor.Run the Service Diagnostics Exit BeltHome Position Sensor test.Does the sensor operate?Go to Step 3. Replace thesensor. If the errorpersists, go toStep 3.3 Test the Staple Motor.1. Close the Interlock Switches for test.2. Run the Service Diagnostics StapleMotor tests.Does the motor operate?Replace theFinisher ControlBoard (page 5-46).If the error persists,go to Step 4.Go to Step 4.4 Check for +24 V to the Staple Motor.Disconnect CN59.Is there +24 V across CN59-1 and -2 <=>ground?Replace the StackHandling Motor(page 5-60).Replace theharness. If theerror persists, goto Step 5.5 Check all pins of the Inverter InterfaceCable for continuity.Disconnect CN1 and CN2 from the FinisherControl Board and the opposite end fromthe Inverter.Is the cable conductive?Replace the InverterPower Supply(page 5-56).Replace the cable.
