3-14 Phaser 6280 Color Laser Printer Service ManualError Messages and CodesJam at Tray 3 (Feeder 2 Jam)Paper fed from Tray 3 did not reach the Registration Sensor on time.Applicable Chain Link■ Chain Link 072-100: Jam at Tray 3Initial Actions■ Try picking paper from a different tray.■ Check the paper path for obstructions or debris.■ Cycle printer power.■ If the problem persists, follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map References■ Regi Sensor, PL3.2.30■ Regi Sensor Harness, PL3.2.37■ MCU Board, PL9.1.20■ Right Side Harness, PL10.1.15■ Optional 550-Sheet Feeder, PL12.1.1■ Tray 3 Feed Clutch, PL12.1.6■ Optional Feeder Assy., PL12.1.8■ Optional Feeder Harness, PL12.2.3■ Tray 3 Turn Roll, PL12.3.4■ Tray 3 Feed Roll, PL12.3.29■ “Map 2 - Laser Unit, Feeder Assembly”on page 10-10■ “Map 4 - LVPS and MCU Boards” onpage 10-12■ “Map 6 - Optional 550-Sheet Feeder” onpage 10-14■ “Tray 1 (MPT) and Registration” onpage 10-23■ “Optional 550-Sheet Feeder WiringDiagram” on page 10-39Troubleshooting Procedure TableStep Actions and Questions Yes No1 1. Check the paper condition.2. Is the paper damaged?Replace thepaper.Go to step 2.2 1. Check the paper setting.2. Does the paper in use match withthe paper settings on the printer’sControl Panel?Go to step 3. Correct thepaper settingsusing theprinter’s ControlPanel.Go to step 3.3 Does the error still occur? Go to step 4. Complete.4 1. Reseat the paper tray.2. Does the error still occur?Go to step 5. Complete.
