Phaser 6280 Color Laser Printer Service Manual 3-27Error Messages and CodesJam at Exit 1/Exit 2The Exit Sensor does not turn Off or the Exit Sensor detects turn Off too earlyafter a paper is detected by the Exit Sensor.WarningThe Fuser may be hot. Turn the printer power Off and allow at least 5minutes for the Fuser to cool before removing the Fuser.Applicable Chain Link■ Chain Link 077-102: IOT Exit1 JAM■ Chain Link 077-103: IOT Exit2 JAMInitial Actions■ Ask the customer about the paper types being used. If not on therecommended list, determine if this is contributing to the problem.Recycled, multi-purpose or copier paper tends to contaminate the paperpath. Constant use of special papers such labels or business cards canalso contribute to jamming.■ Ensure the correct tray loading and setup procedures are followed(securing the guides, selecting the correct paper type, fanning the paper,etc.)■ Make sure the printer is plugged directly into an electrical outlet. Usingextension cords or a power strip is not recommended.■ Make every attempt to establish a jam rate prior to starting any work. Ifpossible print an Error History Report and note the page count betweenjams.■ Determine if jamming is occurring in one tray but not another. This helpsto identify any dirty or defective parts.■ Clear the paper path of any jams and paper debris. Start at the TurnChute and work up to the Registration Chute Assembly.■ Clean the paper Feed and Retard Rollers in the paper tray and tray slotusing a slightly damp (water only) lint free cloth.■ Cycle printer power.■ If the problem persists, follow the following procedure.
