Phaser 6280 Color Laser Printer Service Manual 3-51Error Messages and CodesConsumable/Routine Maintenance ProceduresInsert FuserThe printer does not detect the presence of the Fuser.WarningThe Fuser may be hot. Turn the printer power Off and allow at least 5minutes for the Fuser to cool before removing the Fuser.Applicable Chain Link■ Chain Link 010-317: IOT Fuser DetachedInitial Actions■ Ensure that the Fuser latches are fully locked.■ Cycle printer power.■ If the problem persists, follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map Reference■ Fuser, PL6.1.10■ Fuser Harness, PL6.1.11■ MCU Board, PL9.1.20■ “Map 1 - Electrical and Drive” onpage 10-9■ “Map 4 - LVPS and MCU Boards” onpage 10-12■ “Fuser” on page 10-35Troubleshooting Procedure TableStep Actions and Questions Yes No1 1. Check the Fuser for correct installation.2. Is the Fuser correctly installed?Go to step 3. Reseat theFuser(page 8-11).Go to step 2.2 Does the error still occur? Go to step 3. Complete.3 1. Check the wiring harness connectors P/J17 and P/J171 between the MCU Boardand the Fuser.*2. Are the connectors securely connected?Go to step 4. Reconnecttheconnectors.Go to step 4.
