802.1X AuthenticationXerox WorkCentre 3315DN/3325DN/3325DNISystem Administrator Guide131802.1X AuthenticationThis is the procedure to follow to install and setup 802.1X Authentication:• Overview on page 131• Information Checklist on page 131• Enable 802.1X at the machine on page 131OverviewThe Xerox machine supports IEEE 802.1X Authentication via Extensible Authentication Protocol (EAP).IEEE 802.1X ensures all machines on the network are authenticated and authorized to use thenetwork. 802.1X can be enabled for machines connected through wired Ethernet networks.The Administrator can configure the machine to use one EAP type. EAP types supported on themachine are:• EAP-MD5• PEAP• EAP-MSCHAPv2• TLSInformation ChecklistBefore starting please ensure that the following items are available and/or the tasks have beenperformed:• 802.1X authentication must be supported on the network where the machine is connected.• Ensure that your 802.1X Authentication Server and authentication switch are available on thenetwork.• Create a User Name and Password on your Authentication Server which will be used toauthenticate the machine.Note Write down the User Name and Password and keep in a safe place.Enable 802.1X at the machine1. Press the Machine Status button on the control panel.2. Press the Up/Down arrow buttons to highlight Network Settings and press OK.3. Enter the Administrator Password using the alphanumerical keypad. The default is 1111. Refer toAdministrator Access on page 19.4. Press the OK button, the Network Settings menu displays.5. Press the Up/Down arrow buttons to highlight 802.1x and press OK.6. Press the Up/Down arrow buttons to highlight On; press OK.7. Press the Up/Down arrow buttons to highlight one of the following for the AuthenticationMethod:
