TCP/IPXerox WorkCentre 3315DN/3325DN/3325DNISystem Administrator Guide315. In the Network Settings link select TCP/IPv6 from the directory tree.6. Select the Enabled checkbox to enable IPv6 protocol.7. To set a manual address, select Enable Manual Address and enter the address and prefix in theAddress/Prefix area. Information in the Assigned IPv6 Addresses box is automaticallypopulated.8. The machine performs auto-address DHCPv6 configuration every time it powers up. This is usedfor neighbor discovery and address resolution on the local IPv6 subnet. However, you can chooseto use manual configuration, automatic configuration or a combination of automatic and manualconfiguration.In the Default Dynamic Host Configuration Protocol Version 6 (DHCPv6) area, select one of thefollowing options:• Use DHCP as directed by a router - this option is fully automatic. The DHCPv6 Addresswill be obtained and displayed on the screen.• Always Enable DHCP - this option is fully automatic. The DHCPv6 Address will beobtained and displayed on the screen.• Never use DHCP - when this option is selected, you must configure the Manual AddressOptions and DNS separately.9. In the Domain Name System Version 6 (DNSv6) area:a. Enter valid details in the IPv6 Domain Name field.b. Enter an IP addresses for the Primary DNSv6 Server Address and Secondary DNSv6 ServerAddress.c. Check the Dynamic DNSv6 Registration checkbox to enable this option.Note: If your DNS Server does not support dynamic updates there is no need to enable DDNS.10. Select Apply to save the changes.11. Select OK when the acknowledgement message displays.Note: Enabling or disabling the TCP/IPv6 protocol will take effect after the system is rebooted.Enabling or disabling TCP/IPv6 will impact other protocols, for example LPR/LPD, SNMP, RawTCP/IP Printing and DHCPv6 over TCP/IPv6.Test Access1. At your workstation, open the Web browser and enter the TCP/IP Address of the machine in theAddress bar. Press Enter.If you use the domain name to specify the machine, use the following format.http://myhost.example.comIf you use the IP address to specify the machine, use one of the following formats depending onyour machine configuration. An IPv6 address needs to be enclosed in square brackets.IPv4: http://xxx.xxx.xxx.xxxIPv6: http://[xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx]Note: If you have changed the port number from the default port number “80”, append thenumber to the Internet address as follows. In the following examples, the port number is 8080.Domain name: http://myhost.example.com:8080IPv4: http://xxx.xxx.xxx.xxx:8080
