Machine Parts and Connection PortsXerox WorkCentre 3315DN/3325DN/3325DNISystem Administrator Guide21Configure Ethernet SettingsThe Ethernet interface will automatically detect the speed of your network. The machine supportshub/switch speeds of:• Automatic• 10 Mbps Full-Duplex• 100 Mbps Full-Duplex• 10 Mbps Half-Duplex• 100 Mbps Half-Duplex• 1 Gbps FullSet the Ethernet speed on the machine to match the speed set on your hub or switch:Setting the Ethernet Speed at the Machine1. Press the Machine Status button.2. Press the Up/Down arrow buttons to highlight Network Settings and press OK.3. Enter the Administrator Password using the alphanumerical keypad. The default is 1111. Refer toAdministrator Access on page 19.4. Press the Up/Down arrow buttons to highlight Ethernet Speed and press OK.5. Press the Up/Down arrow buttons to highlight one of the following speeds:• Automatic• 10 Mbps Half• 10 Mbps Full• 100 Mbps Half• 100 Mbps Full• 1 Gbps Full6. Press OK. The Saved screen displays followed by the Reboot Required message.To reboot the machine, press the power switch off, wait two seconds and press the power switchback on.To set the Ethernet Speed using Internet Services, refer to Setting the Ethernet Speed Using InternetServices on page 26.Print a Configuration ReportThe Configuration Report details the machine software versions and network settings configured forthe machine.Print a Configuration Report at the Machine1. Press the Machine Status button.2. Press the Up/Down arrow buttons to highlight Information Pages and press OK.3. Press the Up/Down arrow buttons to highlight Configuration Page and press OK.
