CopyingWorkCentre 7120 Multifunction PrinterUser Guide101Stapling CopiesIf the printer has the optional Integrated Office Finisher, copies can be automatically stapled with onestaple. The Office Finisher LX can automatically staple with two staples.To select stapling:1. Touch Copy on the touch screen.2. Under Copy Output, touch Collated 1 Staple.3. For additional stapling options, touch More.Note: Stapling options are dependent upon paper feed orientation (short edge or long edge). Ifthe desired stapling option is unavailable, touch Paper Supply, then choose the appropriate tray.a. Under Staple, touch 1 Staple, 2 Staples or 2 Staples Top. The screen shows the location ofthe staple on the page.b. If necessary, touch Paper Supply to select the tray loaded with the required paper.c. Touch Save.Creasing CopiesIf the printer has the Office Finisher LX with Booklet Maker option, copies can be automaticallycreased. You can then fold the copies to make a booklet.Note: Creasing options are dependent upon paper size and feed orientation. The paper must befed from a tray with the paper loaded for short edge feed. If the creasing button or the desiredcreasing option is unavailable, touch Paper Supply, then choose the appropriate tray.1. Touch Copy on the touch screen.2. Under Copy Output, touch Creasing, then touch Single Crease.3. To crease and stack each page separately, under Pages to Crease, touch Crease a page at a time,or touch Crease as a Set. If desired, when Crease as a Set is selected, touch Staple to staple thepages at the crease.4. Touch Save.Hole Punching CopiesIf the printer has the Office Finisher LX with the Hole Punch option, copies can be automaticallyhole punched.Note: Hole punch options are dependent on paper size and feed orientation. The paper can be fedfrom a tray with the paper loaded for short edge feed.or long edge feed. If the desired hole punchoption is unavailable, touch Paper Supply, then choose the tray containing the paper in thecorrect orientation.1. Touch Copy on the touch screen.2. Under Copy Output, touch More.3. Under Hole Punch, touch 2 Hole Punch, 3 Hole Punch, or 4 Hole Punch. Select Top if desired.Note: Hole punch settings vary based on printer configuration.4. Touch Save.
