10 General Class ObjectsEN 42 YASKAWA ELECTRIC SIEP C730600 58A 1000-Series Option SI-EN3 Technical Manual TCP/IP Object 245 (Class 0xF5) Services Supported Attributes Supported1 16 Input Voltage (V) Drive Input VoltageUnit is affected by Voltage Scale (VS). O – Word –DependsonCapacity1 17 Output Voltage (V) Drive Output VoltageUnit is affected by Voltage Scale (VS). O – Word – 01 18 Accel Time (ms)Acceleration Time 1 (C1-01)Units set in parameter C1-10.Unit is affected by Time Scale (TS).O O Word – 2710H1 19 Decel Time (ms)Acceleration Time 1 (C1-02)Units set in parameter C1-10.Unit is affected by Time Scale (TS).O O Word – 2710H1 20 Low Speed Limit Percent ofMax Speed Frequency Reference Lower Limit (d2-02) O O Word 0 to 1100 01 21 High Speed Limit Percent ofMax Speed Frequency Reference Upper Limit (d2-01) O O Word 0 to 1100 3E8H1 22 Speed Scale(-15 to 15)Setting for F7-17, scale of units for speedrelated data. O O Byte -15 to 15 01 23 Current Scale(-15 to 15)Setting for F7-18, scale of units for currentrelated data. O O Byte -15 to 15 01 24 Torque Scale(-15 to 15)Setting for F7-19, scale of units for torquerelated data. O O Byte -15 to 15 01 26 Power Scale(-15 to 15)Setting for F7-20, scale of units for powerrelated data. O O Byte -15 to 15 01 27 Voltage Scale(-15 to 15)Setting for F7-21, scale of units for voltagerelated data. O O Byte -15 to 15 01 28 Time Scale(-15 to 15)Setting for F7-22, scale of units for speedrelated data O O Byte -15 to 15 01 29 Reference from Net (Status)Status of Reference Command (1 = Network).0: As set by the drive parameters (i.e., b1-01)1: NetworkO – Byte – 0Service Code No. (hex) Service Name01 Get Attribute All0E Get Attribute Single10 Set Attribute SingleInstanceID Attribute Name Description Get Set Size Range Default0 1 Object Software Revision Revision number of the TCP/IP Object O – Word – 11 1 StatusBits 0-3 = Interface Status0: Interface has not been configured1: Interface Configuration is valid,obtained from BOOTP, DHCP, or NVRAM2: Interface Configuration is valid andobtained from hardware settings3: ReservedBit 4 = Multicast PendingBits 5-31 = ReservedO – DWord – –1 2 Configuration CapabilityBit 0 = BOOTP ClientBit 1 = DNS ClientBit 2 = DHCP ClientBit 3 = DHCP-DNS UpdateBit 4 = Configuration SettableBits 5-31 = ReservedO – DWord – –InstanceID Attribute Name Description Get Set Size Range Default