www.dadehpardazan.ir 88594014-1510.3 List of Monitor Displays10-3310Appendix10.3 List of Monitor DisplaysThe following list shows the available monitor displays. For details, refer to 8.6 Monitoring Input Signals. For details, refer to 8.7 Monitoring Output Signals. For details, refer to 8.3 Reading 32-bit Data in Decimal Displays. For details, refer to 5.4.4 Electronic Gear. If the reference pulse input multiplication switching function is enabled, the reference pulse will be multiplied by n toobtain the reference. This function is supported by software version 001A or later. The monitor Un022 can be used only with SGDV-B SERVOPACKs. For details, refer to 2 Installationof-V Series USER’S MANUAL, Setup, Linear Motor (No.: SIEP S800000 44).ParameterNo. Description UnitUn000 Motor moving speed mm/sUn001 Speed reference mm/sUn002 Internal force reference (in percentage to the rated force) %Un003*3 Electric angle 1 (number of linear-scale pulses from polarityorigin: decimal display) linear scale pulse4Un004 Electric angle 2 (from polarity origin (electric angle)) degUn005*1 Input signal monitor Un006*2 Output signal monitor Un007*5 Input reference pulse speed (valid only in position control) mm/sUn008*5 Position error amount (valid only in position control) reference unitUn009 Accumulated load ratio (in percentage to the rated force: effec-tive force in cycle of 10 seconds) %Un00ARegenerative load ratio (as a percentage of the processableregenerative power: regenerative power consumption in cycleof 10 seconds)%Un00BPower consumed by DB resistance(in percentage to the processable power at DB activation: dis-played in cycle of 10 seconds)%Un00C*3, *5 Input reference pulse counter reference unitUn00D*3 Feedback pulse counter linear scale pulse4Un010 Allowable motor maximum speed and encoder output resolu-tion Un011 Hall sensor signal Un012 Total operation time 100 msUn013*3 Feedback pulse counter reference unitUn014 Effective gain monitor (gain settings 1 = 1, gain settings 2 = 2) Un015 Safety I/O signal monitor Un020 Motor rated speed mm/sUn021 Motor maximum speed mm/sUn022*6Installation environment monitor(Operation conditions in various environments can be moni-tored.)%Un084 Linear scale pitch (Scale pitch = Un084 10Un085 [pm]) Un085 Linear scale pitch index (Scale pitch = Un084 10Un085 [pm])